![routing - What does the notation F0/0 and F0/1 mean in this diagram? - Network Engineering Stack Exchange routing - What does the notation F0/0 and F0/1 mean in this diagram? - Network Engineering Stack Exchange](https://i.stack.imgur.com/VWfe6.png)
routing - What does the notation F0/0 and F0/1 mean in this diagram? - Network Engineering Stack Exchange
![How to Configure Cisco Router Interfaces (FastEthernet and Serial Interfaces)-Cisco Certifications – UPaae How to Configure Cisco Router Interfaces (FastEthernet and Serial Interfaces)-Cisco Certifications – UPaae](https://upaae.com/wp-content/uploads/2016/08/config-interface-2.jpg)
How to Configure Cisco Router Interfaces (FastEthernet and Serial Interfaces)-Cisco Certifications – UPaae
![Serial Point-to-Point Overview (3.1) > Cisco Networking Academy Connecting Networks Companion Guide: Point-to-Point Connections | Cisco Press Serial Point-to-Point Overview (3.1) > Cisco Networking Academy Connecting Networks Companion Guide: Point-to-Point Connections | Cisco Press](https://www.ciscopress.com/content/images/chap3_9781587133329/elementLinks/03fig14_alt.jpg)
Serial Point-to-Point Overview (3.1) > Cisco Networking Academy Connecting Networks Companion Guide: Point-to-Point Connections | Cisco Press
![static routing configuartion on cisco router using serial port. | Learn Linux CCNA CEH IPv6 Cyber-Security Online static routing configuartion on cisco router using serial port. | Learn Linux CCNA CEH IPv6 Cyber-Security Online](https://linuxtiwary.files.wordpress.com/2015/03/staic-routing-using-serial-port.png?w=640)
static routing configuartion on cisco router using serial port. | Learn Linux CCNA CEH IPv6 Cyber-Security Online
![Refer to the exhibit. After the configuration shown is applied on router R1, the exhibited status message is displayed. Router R1 is unable to form a neighbor relationship with R2 on the Refer to the exhibit. After the configuration shown is applied on router R1, the exhibited status message is displayed. Router R1 is unable to form a neighbor relationship with R2 on the](https://itexamanswers.net/wp-content/uploads/2015/06/i212832v1n3_212832.png?ezimgfmt=rs:380x217/rscb2/ngcb2/notWebP)
Refer to the exhibit. After the configuration shown is applied on router R1, the exhibited status message is displayed. Router R1 is unable to form a neighbor relationship with R2 on the
![Interface and Line Numbers in Cisco Routers - DavidontheCloud.com - David Papkin Technical Resources Interface and Line Numbers in Cisco Routers - DavidontheCloud.com - David Papkin Technical Resources](https://www.cisco.com/c/dam/en/us/support/docs/routers/3725-multiservice-access-router/62611-62611b.gif)